Laser Cutter Problem

Was using laser cutter today when the laser beam stopped. The laser head movement actuators continued to run but no beam. Rebooted the laser computer, changed colours of parts being cut to no avail. Laser cutter does not produce a beam for either cut or engrave mode. Created a new laser cutter diagram but had the same results.

Occasionally the laser head will generate a couple of flashes but not for any length of time.

Have only played with software in troubleshooting as I don’t know how the hardware works.

Have posted out of order notice on laser cutter and laser computer.


The @lcc is aware and will follow up on this


Following up in dedicated thread: