Laser cutter + CNC vertical mill for sale

I’m moving to a smaller place and it’s your gain!

  1. I have a Tormach 770 CNC vertical mill with an 8? automatic tool changer, coolant sprayer, chip shield, clamps, work holding plate, dial indicator, calipers, touch probes (x3?), 123 block, parallels, some spare aluminum for doing test cuts, extra oil and spray, tooling, manual, computer, jog tool, and more. Like new. All in it cost me >$15k. I’d be delighted to get $11k. It would be amazing to see it replace several janky looking machines in the back of VHS. It’s a great learner speed and size.

  2. laser cutter! 60w, 800x600mm work area. Same brand as the one at VHS, just a little smaller. Includes all the original CDs, a windowsXP laptop to run it, air compressor, water pump, replacement laser tube. This type the bed can be lowered up to 30cm? so you could engrave really big items or install a rotary axis. New was $5k. I’d be delighted to get $3k. Double your laser, double your fun?

Offer good until July 1, 2025, at which time I send them to Able auctions.




3 Likes

Hi Dan,

Thank you for your kind offer! There is definitely interest in the Tormach among the CNC folks.

Your July 1st deadline is noted!

Mark

I can get you some paperwork - for a 10% deposit to secure the purchase I can hold on to it until the 22nd. that’s three more weeks to make room and so on.

FWIW it has less than 50h run time and all the bearings are good.
One clamp on one v-block has a nick from a poorly planned travel move.
The battery in the motherboard might need replacing, the last time I turned it on (yesterday) I had to reset the BIOS clock.
Other than that it’s in perfect working order.

1 Like

The CNC mill is sold but has not been picked up yet.

1 Like