Help wanted - Soldering tiny wires to testpads for an internal Nintendo Switch Hack


#1

Hey guys,
I’m working on an internal hardware exploit for loading custom firmware on the Nintendo Switch. Here is a detailed write up: https://github.com/Quantum-cross/sam-fusee-launcher-internal
For short, it uses an Adafruit Trinket M0 to inject the payload into the switch. In order to make the process automatic (injection is needed on every startup), I have to solder the Trinket M0 to some tiny test pads on the motherboard.
I tried doing them myself but wasn’t able to do it, I’m not experienced enough to solder tiny wires on to tiny pads :frowning:
If anyone can give a hand on the soldering part, please PM me or leave your contact down below! Much appreciated :stuck_out_tongue:
Here is an image of the Trinket M0 and the Switch’s motherboard, and a ruler for scale: